|
|
FM3212 - 12-Port 10-Gigabit Ethernet Multi-Layer Switch
The FM3212 is a single chip wire-speed 10-Gigabit Ethernet multi-layer switch chip that leads the market in low-latency deep packet inspection along with providing the QoS and congestion management features required in applications such as Telecom backplanes and Carrier Ethernet switch-routers. The FM3212 has 12 interfaces that can independently function in 10G XAUI, or 10/100/1000/2500 SGMII modes.
FM3212 Features
Performance
- Output queued, shared memory switch
- The industry’s lowest latency
- 300ns, ball to ball with packet inspection enabled
- Up to 12 XAUI (CX4) interfaces
- CX4 compliant for copper cable support (up to 15m)
- Each interface supports 10/100/1000/2500 SGMII modes
- Performance-optimized design
- Cut-through (or store-and-forward)
- 180M packets per second sustained throughput
Layer 3
- ACL support
for deep packet inspection
- L2/L3/L4 awareness
- Up to 4K extended ACLs
- Egress ACLs supported
Layer 2
- Sophisticated queue management
- 8 internal priority levels (802.1P support)
- Strict priority and weighted round robin scheduling
- Traffic shaping
- High performance multicast
- Advanced flow control
- Class-based pause
- Virtual output queue Congestion Notification (VCN)
- Per-port configurable
- Symmetric or asymmetric support
- Extensive 802.1Q VLAN support
- 4K-entry table
- Port- or MAC-based association
- Support for Q-in-Q (double-stacked) VLANs
- MAC addresses
- 16K-entry table
- Multiple Spanning Tree (802.1D, s, w)
- Configurable hardware aging, with lockable entries
Switch virtualization and scaling
- Single point of management
- Remote learning
- Fat trees, meshes, rings
- Multi-chip mirroring
- Multi-chip LAG, 16 ports/group, 256 groups/system
Convergence capabilities
- Line rate classification
- L2/L3/L4 traffic classification, metering, and policing
- 802.1p, IPv4, IPv6 DSCP
- Advanced IEEE congestion management
- 802.3x class-based PAUSE flow control
- 802.3ar rate control
- Partitionable shared memory ensures traffic separation
- Flexible, multi-level scheduling
- 200 ordering queues
Security
- Port-based security (802.1X)
- MAC address security
- DOS prevention
Switch management
- MDIO, GPIO, I2C, SPI interfaces
- JTAG, and Serial LED interfaces
- Unmanaged mode
- Sophisticated statistics gathering
- RMON, priority, flow, congestion control, VLAN
Process and package
- 130 nm CMOS process technology
- 1433-ball Ball Grid Array package
FM3212 Applications
The FM3212 can be used as the backplane fabric or system-level interconnect for a variety of platforms and applications, including:
- ATCA platform backplane fabric
- Carrier Ethernet backplane switch
- Load distribution in Telecom Servers
|
